A Do-It-Yourself Adventure

Bookmark This Page  |  Send To A Friend

Leslie and Sal: Presidents Day Weekend 2003
Installation of our 7' x 13' Endless Pool
Here's the adventure!
(The following photo story was taken with permission from http://www.geocities.com/saglibene2003)
(Part 3 of 5)

 

OK, Now how do I get out? I am a bit heavy in the back end to lift myself out!

Les makes it out and liner is easily put into place.

The Endless Pool "Suck out the Air Vacuum Trick" to get liner into correct place. Worked Great!

With supplied filter on hose we get our first water. 50 degrees!

Working on the pool front plumbing connections.

Removing the film from the stainless steel propulsion housing - what do they use on this stuff!

Propulsion housing in place - water is still 50 degrees and I am close to hypothermia!

Installing the stainless steel benches. Sal is numb from the cold water but he is still smiling! Les is out of the pool and refuses to get in until heater is activated. What a wimp!

Measure, cut, clean, glue lots of plumbing fittings.

Finishing up hydrotherapy connections. Lets give it a trial run!

Mopping up after our trial run. After a call to tech support at Endless Pools we solve our problem. Forgetting to put 2 washer in each jet we had water pumping out into the room instead of into the pool. Rather exciting!

 

1 | 2 | 3 | 4 | 5  >> Next